Sold both. I'm sorry, I have not check this site in weeks.

They are sold, sorry I have not been here for a while. Sold the Paso.

I sold the Paso so now I'll sell the F1's, nice shape,no logos, $100 plus shipping.

Thanks for the numbers.

Now that I have the rear end in order with chain, sprockets and wheel bearings it seems I need new front rotors. :-( I have .005 to 008 run out on both rotors and they are too thin to turn or grind. Are there any after market rotors? I found a right hand side (?)( I would assume left and right are t...

An update on the bearings. I bought the 6204-2RS1/C3 went to put them in and low and behold the ID is to small. Back to the bearing with the hold one in hand he gives me an NACHI 6005-2NSE which fit fine. So morale of story always bring your old bearings with you when you buy new ones. Now to find o...

OK I figured it out. Got home from work, I took a good look at the sprocket, take one big socket, one dead blow hammer, a couple of good whacks and the bearings are out. New ones are in the, freezer I'll put them in later.

Thanks. Are they hard to get out? Not much of edge to hit with a drift.

Are there two bearings in the sprocket carrier? It looked like just one to me but the FAG says 2x.
Thanks

I order the wheel bearings from a bearing dealer in Hartford. $28 each for the RFKs which was the only brand that had the right size. Ouch, I paid $8 for per bearing for the LeMans. I'll check on having the disc turned. I'm thinking of selling the Paso now that its all sorted. I always end up doing ...

Well I answered my own question, they tap out, no problem. Looks like the sprocket bearing is also shot.

While giving the Paso a look over I found that there is side play in the rear wheel. Before I pull off the wheel is there anything I should know about replacing the rear wheel bearings? Is it just a matter on knocking them out like I do on a Guzzi? Then tapping back in? On the plus side, the bike st...

I'll go with the BUBs. I have owned a few sets for Guzzis and they look like that.

Thanks, a good read.

So what size wheels and what is the carburetor? Paso owners need to know.