Rear Brembo pump

Stefano · Post by **Stefano** » Mon Oct 29, 2007 9:19 pm

What is the name (code) of the rear brembo pump of Paso 750?
(PS 11 B)???????????

DaveM · Post by **DaveM** » Tue Oct 30, 2007 8:23 am

this is from the part micro fiche : rear brake pump # 066441300.
hope it helps you.

Dave

Desmo_Demon · Post by **Desmo_Demon** » Tue Oct 30, 2007 2:14 pm

I contacted Brembo a little over a month ago about the model of master cylinder and a rebuild kit for it. This is the response that I got (these are Brembo part numbers).....

In regards to your inquiry, your bike should have the 20.2945.12 P108 caliper OE on the rear of the bike. The seal set you need is 120.2741.40.

You can purchase these from either of the following distributors:

TAW @ 303-456-5544
Yoyodyne @ 973-386-0040

Stefano · Post by **Stefano** » Thu Nov 01, 2007 6:21 am

Desmo_Demon wrote:I contacted Brembo a little over a month ago about the model of master cylinder and a rebuild kit for it. This is the response that I got (these are Brembo part numbers).....

In regards to your inquiry, your bike should have the 20.2945.12 P108 caliper OE on the rear of the bike. The seal set you need is 120.2741.40.

You can purchase these from either of the following distributors:

TAW @ 303-456-5544
Yoyodyne @ 973-386-0040

Do you know the difference between the rear pump PS12 of Paso and the PS11B of 900ss from 91?

Desmo_Demon · Post by **Desmo_Demon** » Thu Nov 01, 2007 12:15 pm

Stefano wrote:Do you know the difference between the rear pump PS12 of Paso and the PS11B of 900ss from 91?

Sorry, but I do not know the difference. I bet the guys at Brembo can help. This is the guy who responded to my request for information on the Paso....

Jason Hilliker
Motorcycle Sales Supervisor

High Performance Division

BREMBO NORTH AMERICA INC.
1585 Sunflower Avenue, Costa Mesa, CA 92626-1532
T (714) 641-0104 ext.238 F (714) 641-5827
Toll Free (800) 325-3994
jhilliker@brembo.com
http://www.brembo.com

Post by **paso750** » Fri Nov 02, 2007 2:05 pm

the PS11B piston is by 1mm smaller than the one of the PS12. next to this obvious difference the B models have the exit for the brake line not on the lower end of the housing, but it`s on the side.

G.

Stefano · Post by **Stefano** » Sun Nov 04, 2007 8:37 pm

paso750 wrote:the PS11B piston is by 1mm smaller than the one of the PS12. next to this obvious difference the B models have the exit for the brake line not on the lower end of the housing, but it`s on the side.

G.

Gerhard Mr. know it all

Post by **paso750** » Sun Nov 04, 2007 8:56 pm

the internet knows things like these, I don`t

Rear Brembo pump

Rear Brembo pump

Brembo Rear Master Cylinder

Re: Brembo Rear Master Cylinder

Re: Brembo Rear Master Cylinder