ducatipaso.org
http://forums.ducatipaso.org/

Replacing the Digiplex S2 on the 906 Paso
http://forums.ducatipaso.org/viewtopic.php?f=2&t=6105
Page 2 of 2

Author:  Spaggy [ Mon Oct 29, 2018 1:31 pm ]
Post subject:  Re: Replacing the Digiplex S2 on the 906 Paso

I need a new box, so am trying various sources, but wondered if anyone using this site has a working one they are prepared to part with.
It will be for a 906.
I'm in the UK so it will be worth checking the cost of postage.
Thanks

Author:  JWilliam [ Wed Nov 28, 2018 11:29 pm ]
Post subject:  Re: Replacing the Digiplex S2 on the 906 Paso

ducinthebay wrote:
Got my new Digiplex in the mail last week. Installed it yesterday, and went for a ride today.


I've said this before, change the standard ignition coils to modern units from eg. an Aprilia. The standard coils have a very low impedance (<0.8 Ohm) that causes overheating of the Digiplex. With a high impedance (3.5 Ohm) coil the unit is not overdriven and is quite reliable, my Paso stil has the original Digiplex.

Author:  Spaggy [ Tue Dec 04, 2018 1:25 am ]
Post subject:  Re: Replacing the Digiplex S2 on the 906 Paso

JWilliam wrote:
my Paso stil has the original Digiplex.

Mine still would have too if I hadn't been such a dipstick and put a new battery on with the terminals reversed.
Cue melting wiring and smoke, and a non-working ignition system.
I have a new IgniTech one now so will see how that goes.

Page 2 of 2 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/