Wellnuts / Fairing Mounts

discussions specific to the 907IE
Post Reply
pseudonoise
Posts: 9
Joined: Fri Aug 29, 2014 12:25 am
model: 907 I.E.
year: 1993
Location: USA

Wellnuts / Fairing Mounts

Post by pseudonoise »

Not sure if anyone posted this yet but just in case...
here's a good source for the m6 wellnuts that hold the bodywork together on the 907 (and other models I suppose).

http://www.desmoparts.com/products/part ... 6-wellnuts

At $0.70 ea. you can't beat it. Shipping was a bit more than I wanted to pay but hey, my bike is back together so I can't complain.
20YearOwner
Posts: 40
Joined: Wed Aug 01, 2007 12:00 am
model: 750 Paso
year: 1987
Location: Bristol, Connecticut USA

Re: Wellnuts / Fairing Mounts

Post by 20YearOwner »

Re: Well Nuts / Fairing Mounts for Paso 750 & 900

Check out a fastener company - Auto Vehicle Parts Company located in Cold Springs, KY 41076 USA. The well nuts have been used on auto's since the 1940's, (Au-Ve-Co Products) the short part # 13003, the long part number is 8-21641-13003-7. They are sold in a box of 50 pcs. shown as M6-1.0, with a range of 0.15-.094. There is also a General Motors part number # 20130258 as a cross reference.

Good Luck!!!
Post Reply