ducatipaso.org

I am in need of the swing arm chain slider (44710081A) for my recently acqiured 907ie. I realize they are NLA but I'm hoping someone might have one they are willing to part with. For that matter if someone would loan me one or have a blueprint of one I will have my machinest make one from delrin. Until I have something in place the bike is idle.
Thank You,
Mark

I think ST4S and monsters with alloy s.arms use same adjusters.

When I had an ST4s I replaced the chain sliders. They are definitely different with 2 pieces, one on top and the other under the swinging arm.

Mark, do you have someone capable of creating .dwg files if I provide the dimensions?

G.

anyone?

G,
Thank you for replying but sadly I do not know of anyone who can create drawing files from dimensions.
Mark

did you ever find a chain slider? I have a NOS still in the ducati plastic bag..

I'll take it off your hands if you like, I should be able to get it 3d scanned and create a file for a 3d printer from it

Someone has already done this . I sent one of my new ones to an Aus member for 3d scanning ( and got it back ) BMW851 I think

Not I Hamish, think it may have been a Victorian based member? but do remember there being a whole thread on the 3D printing of chain sliders, but can't seem to find it doing a search for chain slider on this site.

Maybe it was on a different site.

Cheers

Peter

bmw851 wrote:Not I Hamish, think it may have been a Victorian based member? but do remember there being a whole thread on the 3D printing of chain sliders, but can't seem to find it doing a search for chain slider on this site.

Maybe it was on a different site.

Cheers

Peter

Sorry Peter.... I wasn't sure
Hamish

higgy wrote:http://forums.ducatipaso.org/viewtopic. ... ain+slider

Thanks Higgy, obviously didn't try hard enough.

Not a problem Hamish, nice to be remembered, and am still on the hunt for a 907 at the right money and mileage.

Cheers

Peter