going to start putting it together question

discussions specific to the 907IE
Post Reply
bobst2
Posts: 192
Joined: Sun Jul 24, 2011 1:57 pm
model: 750 Paso
year: 1988
Location: delta b.c. canada

going to start putting it together question

Post by bobst2 »

at my electric,s plate near the headlite there are two ground wires 1 goes to the regulator but the other i broken off just hanging there any ideas where it goes
Tamburinifan
paso grand pooh-bah
Posts: 1543
Joined: Thu Jun 21, 2007 12:00 am
model: 907 I.E.
year: 1991
Location: Gothenburg, SWEDEN

Re: going to start putting it together question

Post by Tamburinifan »

Do you have 2 wires from alternator cover to regulator?
Gert

907 I.E. -91
M900 -97
MTS 1100s -07
bobst2
Posts: 192
Joined: Sun Jul 24, 2011 1:57 pm
model: 750 Paso
year: 1988
Location: delta b.c. canada

Re: going to start putting it together question

Post by bobst2 »

yes. two wire stator

i think i figured it out the electric,s board is on rubber isolators so the second one must go two the frame
bobst2
Posts: 192
Joined: Sun Jul 24, 2011 1:57 pm
model: 750 Paso
year: 1988
Location: delta b.c. canada

Re: going to start putting it together question

Post by bobst2 »

well fired it up with the 2 into 1 conti alloy system and it sounds great. had to do a little hammer mods to the front pipes to get propper clearence. started testing stuff found i had no chargeing system but was only a bad connection now that system is working now i am going on to the brakeing system going to need hoses and a proper flush also the micro switch is shot. hopefuly the last of the body panels & stuff arrive soon.i am starting to get anxious to take it for a ride
Post Reply