320 mm. disc brakes project

persempre907 · Post by **persempre907** » Wed Jan 18, 2006 11:06 pm

Hi everybody,
I would want to mount a couple of front disc brakes of 320 mm. of diameter instead of the original discs of 300 mm.
I have a front disc that is not right and the original spare part is much more expensive of a newer and better disc.
But I need of a spacer for the calipers :screwy: !
I would want some advice.
Many thanks.
Ciao.
Francesco

Finnpaso · Post by **Finnpaso** » Thu Jan 19, 2006 7:59 pm

I think Angelix (also from Italy, but living in UK) knows more about this. He have played with this "problem"....

Angelix, where are You ??? huhuuuu! :laugh:

persempre907 · Post by **persempre907** » Sat Jan 28, 2006 2:50 pm

AAAANGELIIIIIIX!!!!!!!
Where are you?

Ciao
Francesco

Finnpaso · Post by **Finnpaso** » Sat Jan 28, 2006 4:18 pm

Here is (his)companys web sites, so try this way:

http://www.excellence-international.com

I havent check, is there mail address to his work, but try to check!

Btw, he bought from Italy same 907IE, what i have lookeed some times. He had some problems with front brakes, vibration, or something, like that... i think here was some discussion about it long time ago.... And he was selling front discs to 907IE... aftermarket ones, but very good ones!

Btw, Dont cry, gigolo, life is not so bad to You! U have only small problems with Paso :funny: :funny: :funny:

persempre907 · Post by **persempre907** » Sun Jan 29, 2006 7:08 am

Thanx Antti,
the website seems to work and they're also interesting things!
I've yet sended him a mail about it. I hope he replies.

Btw, don't laugh too much, w-w gigolo, the pains and the problems come when you don't wait them :neener: :neener: :neener:

Ciao
Francesco