Page 1 of 1
Side Stand modification
Posted: Wed Jun 14, 2006 4:05 pm
by pope
Does anyone have the outline for the side stand modification that prevents the side stand from automatically retracting? I know that you have to make a new plate, but don't have the dimensions.
Thanks,
Doug
Posted: Wed Jun 14, 2006 5:40 pm
by paso750
Posted: Wed Jun 14, 2006 6:43 pm
by Gwenadu
It's very simple: the hexagonal hole is deep enough to use the allen wrench if you cut the top of the screw (cylindric) just over the spheric part. Cut it! Nothing else to do
.
Posted: Wed Jun 14, 2006 8:11 pm
by Gwenadu
It's very simple: the hexagonal hole is deep enough to use the allen wrench if you cut the top of the screw (cylindric) just over the spheric part. Cut it! Nothing else to do .
sorry
! I have just look at my bike: I have not cut all the cylindric part, there is 4mm left above the conic-spheric part.