Page 1 of 1
Rear Brembo pump
Posted: Mon Oct 29, 2007 9:19 pm
by Stefano
What is the name (code) of the rear brembo pump of Paso 750?
(PS 11 B)???????????
Posted: Tue Oct 30, 2007 8:23 am
by DaveM
this is from the part micro fiche : rear brake pump # 066441300.
hope it helps you.
Dave
Brembo Rear Master Cylinder
Posted: Tue Oct 30, 2007 2:14 pm
by Desmo_Demon
I contacted Brembo a little over a month ago about the model of master cylinder and a rebuild kit for it. This is the response that I got (these are Brembo part numbers).....
In regards to your inquiry, your bike should have the 20.2945.12 P108 caliper OE on the rear of the bike. The seal set you need is 120.2741.40.
You can purchase these from either of the following distributors:
TAW @ 303-456-5544
Yoyodyne @ 973-386-0040
Re: Brembo Rear Master Cylinder
Posted: Thu Nov 01, 2007 6:21 am
by Stefano
Desmo_Demon wrote:I contacted Brembo a little over a month ago about the model of master cylinder and a rebuild kit for it. This is the response that I got (these are Brembo part numbers).....
In regards to your inquiry, your bike should have the 20.2945.12 P108 caliper OE on the rear of the bike. The seal set you need is 120.2741.40.
You can purchase these from either of the following distributors:
TAW @ 303-456-5544
Yoyodyne @ 973-386-0040
Do you know the difference between the rear pump PS12 of Paso and the PS11B of 900ss from 91?
Re: Brembo Rear Master Cylinder
Posted: Thu Nov 01, 2007 12:15 pm
by Desmo_Demon
Stefano wrote:Do you know the difference between the rear pump PS12 of Paso and the PS11B of 900ss from 91?
Sorry, but I do not know the difference. I bet the guys at Brembo can help. This is the guy who responded to my request for information on the Paso....
Jason Hilliker
Motorcycle Sales Supervisor
High Performance Division
BREMBO NORTH AMERICA INC.
1585 Sunflower Avenue, Costa Mesa, CA 92626-1532
T (714) 641-0104 ext.238 F (714) 641-5827
Toll Free (800) 325-3994
jhilliker@brembo.com
http://www.brembo.com
Posted: Fri Nov 02, 2007 2:05 pm
by paso750
the PS11B piston is by 1mm smaller than the one of the PS12. next to this obvious difference the B models have the exit for the brake line not on the lower end of the housing, but it`s on the side.
G.
Posted: Sun Nov 04, 2007 8:37 pm
by Stefano
paso750 wrote:the PS11B piston is by 1mm smaller than the one of the PS12. next to this obvious difference the B models have the exit for the brake line not on the lower end of the housing, but it`s on the side.
G.
Gerhard Mr. know it all
Posted: Sun Nov 04, 2007 8:56 pm
by paso750
the internet knows things like these, I don`t
