ducatipaso.org

I have extra fairing nuts if you need them. I can post to USA only. $2ea.

DUCATI 750 & 906 PASO New Replacement Rubber Nuts.

Replacement rubber with brass inserts to fit the bodywork, fairing upper & lowers, side covers and turn signals PASO models 6MM.

PM sent! i could use a few!!

You have any left? If so please PM me. Horse.

Horse wrote:You have any left? If so please PM me. Horse.

you can buy separate well nuts, or a whole Paso fairing bolt kit here:

www.bikebolts.com

I helped him put the kit together so I know it fits a 907ie perfectly. I don't think there's any real difference in the fairing fasteners between 750/906/907.

20YearOwner wrote:Replacement rubber with brass inserts to fit the bodywork, fairing upper & lowers, side covers and turn signals PASO models 6MM.

I have aftermarket fasteners on my Paso.....are these wellnuts standard M6 welnuts? If so, here's a source where they are $0.70 each...

http://www.desmoparts.com/ducati/wellnut/wellnut.htm#

M6 wellnuts are not hard to find,Home depot has them as well as many industrial supply houses
.70US is not a bad price

Yellow bolts are also available in Ducati: here's the one for the ST2 front mudguard:


Sorry for my dirty fingers!!!

After finding the 6MM well nuts on-line for $0.70, with a shipping/handling of $7.00, that was the best deal I could find, but the shipping charges killed it (only needed 6 of them).

I did find them at Lowe's in the hardware section, pretty cool as I had called nut and bolt specialty places, and hardware stores and neither had them. They were $0.92 each, and worked perfectly but if you need more than five, you may have to visit multiple Lowe's because each store will only stock five of them.

In the states you can find them at MSC or McMaster Carr and many Ducati aftermarket sources as well.

Wow thank you! I have been looking for wellnuts for a while, Lowe's saved me from buying a complete and overpriced set of fairing bolts! this would be a good one for the tech faqs...

http://cgi.ebay.com/ebaymotors/25-M6-1- ... ccessories

...and a good source for some black anodized M6 bolts?
Ciao

Francesco,
Any suggestion for Ebay Italy?

Here it is! I've been lucky in finding, in the next days I'll tell you the price they asked me
http://annunci.ebay.it/annunci/ricambi- ... 3#rispondi

Ah !!! The very special MV wellnuts

Update on well nuts:

I found a source for an auto well nut that fits the Paso.

Made by Au-ve-co Products they are located in Cold Springs KY, 41076 USA

Well Nuts, Box of "50", Part #13003, Size M6-1.0

https://www.auveco.com

On the website search for part number 13003.