Standard Ignition wires

higgy · Post by **higgy** » Sun Dec 14, 2008 10:11 pm

Can someone tell me the standard length of the stock ignition wires for a 906? Thanks

Mc tool · Post by **Mc tool** » Wed Dec 17, 2008 10:45 pm

27 kpa

higgy · Post by **higgy** » Wed Dec 17, 2008 11:00 pm

27 kilopascals?

ducapaso · Post by **ducapaso** » Thu Dec 18, 2008 6:30 am

higgy wrote:Can someone tell me the standard length of the stock ignition wires for a 906? Thanks

about... from the coils to the plugs!

whitepaso · Post by **whitepaso** » Thu Dec 18, 2008 6:31 pm

I think he meant "km"

higgy · Post by **higgy** » Thu Dec 18, 2008 11:13 pm

Oh! 27 Kilo Meters much better

higgy · Post by **higgy** » Fri Dec 19, 2008 2:13 am

Actually I'm thinking around 43 cm or 17 inches should do,The ones that came installed are easily twice that and wire tied to the frame amongst the wiring. I see no reason for them to be attached to anything but the coil and the plug and just was curious what came stock.

whitepaso · Post by **whitepaso** » Sat Dec 20, 2008 3:24 am

Oh, so that makes it 13.5 kpa then?

higgy · Post by **higgy** » Sat Dec 20, 2008 2:49 pm

Oh, so that makes it 13.5 kpa then?

Only if your muffler bearing and constant entropy seals are installed properly

Standard Ignition wires

Standard Ignition wires

Re: Standard Ignition wires

Re: Standard Ignition wires

Re: Standard Ignition wires

Re: Standard Ignition wires

Re: Standard Ignition wires

Re: Standard Ignition wires

Re: Standard Ignition wires

Re: Standard Ignition wires