Hi

How do I remove it? It’s a single wire type. (I have removed the sidestand already)

Thanks

Once again, bob on Paso 750. I had a look last night and there is no simple solution just using a different sprocket. Using the threaded Centre hole on the shaft is the way to go. I had thought about a plate attached to end of the output shaft that was machined to offer the groove necessary to use t...

Thanks Derek

Anyone else experimented with this?

Hi So monster wheel is centered and spaced. All good so far. The chain alignment it’s 5 mm out. I need to move the gearbox sprocket out to align. Has anyone any experience or suggestions about how to do this? Can you reverse the sprocket with the locking plate fitted engine side? Thanks for looking...

Hi

I went with new chain adjusters machined to take 17mm spindle...collected today!

Thank you Paso750.

Really helpful... thank you for taking the time to reply.

I’ll let you know how I get on...

Alistair

Hi

I’ve searched but can’t find reference to this. I know it’s possible to fit a Monster 17” rear wheel. Has anyone on here done this? Any tips?

I know of two race Paso’s with this conversion and it’s permissible s in the CRMC Regis.

Which Monster year/size cc ?

Thanks in advance...

Al

Have put a deposit on one... yes, from eBay!

But I thought it was worth asking here too.

Hi

Pretty much as the title says, I am looking for a Paso 750 that’s standard (replacement exhaust fine)

Anyone have one they would part with?

Thanks

Alistair 07786 803 747