Which bearing type for swingarm?

[JoKing]

Hi guys,

i need the type/naming of all swingarm bearings & shaft seals.
I do not want to buy them at ducati. They`d cost more than the swingarm itself.

Anyone knows?

Here the original part #s:
764000001
041202295
751632054
075549265
764000002

Cheers,
Johannes

[JWilliam]

I have only had to replace the bearing and seals for the shock linkage - 5 bearings total. The gearbox/frame pivot bearings were OK so I don't know the exact size for them (the right side is a double sealed type). If this is familiar then I can quote the linkage sizes.

[paso750]

you find them all listed in the FAQs
http://ducatipaso.org/forum/viewtopic.p ... c&start=15
all swingarm bearings are the same on P750/906 & 907ie.

G.

[pasolloyd]

The numbers I retrieved from my swing arm are as follows:
075549265: 26mm x 20mm x 4mm seal
764000002: 260D 201D 18L bearing

Sorry I don't have the others...

Lloyd

[pasolloyd]

Oops!
The others were on the previous page! I can see also some were not part numbers but sizes for the bearings. Let's try again:

764000001: 32mm OD x 25mm ID x 18mm L needle bearing
041202295: 32mm x 25mm x 4mm seal
751632054: #630004 2RS1C3
075549265: 26mm x 20mm x 4mm seal
764000002: 26mm OD x 20mm ID x 18mm L needle bearing

Again, these were taken from my swingarm components

[JWilliam]

Aftermarket bearing sizes then :
Mfr SKF Bearings
Swingarm linkage bearings are 4 x HK2020 Needle bearing,1 x HK2030 Needle bearing and 6 x G20x26x4 Seal

Sprocket Carrier (always a good idea)
2 x 6005 2RS1