My bike has gone more miles without a speedometer cable than it has with one, so when the speedometer started showing 0mph at speed recently, I chalked it up to the cable. I ordered a new cable; but when I took the old one off - it appeared to be serviceable still. Curious, but I figured I'd take a closer look when I tore it all apart to clean up the drive and put the new cable in anyway.
Today was that day. And when I pulled the drive off the axle to clean & inspect it ... I got a better understanding of why the old cable still looked ok: the tab on the drive washer was snapped off. Well that's a nuisance ...
I'm hoping this tab washer @ BevelHeaven will fit. Anyone have another resource, just in case?
Speedo drive tab washer threw in the towel ...
- fasterdammit
- paso grand pooh-bah
- Posts: 708
- Joined: Wed Jan 19, 2005 12:00 am
- model: 750 Paso
- year: 1988
- Location: CNY, US
- Contact:
Speedo drive tab washer threw in the towel ...
Just because you're not dead doesn't necessarily mean you're living, either.
1988 Paso 750 #753965
1997 Monster 750
1988 Paso 750 #753965
1997 Monster 750
- higgy
- paso grand pooh-bah
- Posts: 3334
- Joined: Tue Jul 29, 2008 9:50 pm
- model: 907 I.E.
- year: 1992
- Location: Hilltown,Pennsylvania
- Contact:
Re: Speedo drive tab washer threw in the towel ...
see the whole drive on ebay all the time
Ducati,making mechanics out of riders since 1946
There's no problem so bad that a little fixing can't make it worse! : )
If it ain't broke keep fixin it till it is
88 750
90 906
92 907ie
There's no problem so bad that a little fixing can't make it worse! : )
If it ain't broke keep fixin it till it is
88 750
90 906
92 907ie
Re: Speedo drive tab washer threw in the towel ...
I'm hoping this tab washer @ BevelHeaven will fit. Anyone have another resource, just in case?
that's the same one I ordered and it worked fine.
that's the same one I ordered and it worked fine.
- fasterdammit
- paso grand pooh-bah
- Posts: 708
- Joined: Wed Jan 19, 2005 12:00 am
- model: 750 Paso
- year: 1988
- Location: CNY, US
- Contact:
Re: Speedo drive tab washer threw in the towel ...
Great! Thanks for the info!paisano wrote:I'm hoping this tab washer @ BevelHeaven will fit. Anyone have another resource, just in case?
that's the same one I ordered and it worked fine.
Just because you're not dead doesn't necessarily mean you're living, either.
1988 Paso 750 #753965
1997 Monster 750
1988 Paso 750 #753965
1997 Monster 750
-
- Posts: 22
- Joined: Sat May 10, 2014 4:46 pm
- model: 750 Paso
- year: 1987
- Location: USA
Re: Speedo drive tab washer threw in the towel ...
Could be wrong but may have to replace entire unit. This Ducati part is actually reasonable and about $65 US.
-
- paso grand pooh-bah
- Posts: 1883
- Joined: Wed Dec 05, 2007 12:35 am
- model: 906 Paso
- year: 1990
- Location: New Zealand
Re: Speedo drive tab washer threw in the towel ...
Make sure your speedo and cable is well lubed
I wish I was young again............Id be heaps smarter than last time
- JWilliam
- Posts: 331
- Joined: Wed Oct 06, 2004 12:00 am
- model: 906 Paso
- year: 1989
- Location: Nottingham, UK
Re: Speedo drive tab washer threw in the towel ...
Ha ha, that always makes me laugh. If you have ever dismantled a speedo drive gearbox for the Paso you will find out that the lube 'nipple' closed by a bearing is a dummy. It doesn't feed to the internal splines. The only way to lube the drive is to remove it from the wheel, take off the circlip and gasket, then dribble oil onto it or soak it in oil.Mc tool wrote:Make sure your speedo and cable is well lubed
- fasterdammit
- paso grand pooh-bah
- Posts: 708
- Joined: Wed Jan 19, 2005 12:00 am
- model: 750 Paso
- year: 1988
- Location: CNY, US
- Contact:
Re: Speedo drive tab washer threw in the towel ...
Nope. Ordered the part mentioned in my previous post from Bevel Heaven, and replaced it on my speedo drive. It needed a little coercing from a Dremel (wheel tine was too long, and the inner diameter wasn't perfectly round, so it wouldn't fit, but that wasn't a big deal).wcmiller2002 wrote:Could be wrong but may have to replace entire unit. This Ducati part is actually reasonable and about $65 US.
There's a spring clip that holds it in place on the drive unit, and there's also a thin seal underneath it (almost didn't see mine when I took it apart).
Good to know about the ball bearing "oil port", JWilliam; I didn't dissect mine far enough to see if it worked or not. Good thing I cleaned & lubed it on the bench.
Just because you're not dead doesn't necessarily mean you're living, either.
1988 Paso 750 #753965
1997 Monster 750
1988 Paso 750 #753965
1997 Monster 750
-
- Posts: 22
- Joined: Sat May 10, 2014 4:46 pm
- model: 750 Paso
- year: 1987
- Location: USA
Re: Speedo drive tab washer threw in the towel ...
glad to hear. I love being incorrect on stuff like this when a better solution presents itself.
-
- paso grand pooh-bah
- Posts: 1883
- Joined: Wed Dec 05, 2007 12:35 am
- model: 906 Paso
- year: 1990
- Location: New Zealand
Re: Speedo drive tab washer threw in the towel ...
Ah ha ha ha , did you think that was a grease nipple ? that would have been good to watch . I just used gear oil , put it in the top of the speedo cable and a few days later its on the wheel so I know its getting right thru . I just think the less friction in the cable etc the less stress on the speedo driveJWilliam wrote:Ha ha, that always makes me laugh. If you have ever dismantled a speedo drive gearbox for the Paso you will find out that the lube 'nipple' closed by a bearing is a dummy. It doesn't feed to the internal splines. The only way to lube the drive is to remove it from the wheel, take off the circlip and gasket, then dribble oil onto it or soak it in oil.Mc tool wrote:Make sure your speedo and cable is well lubed
I wish I was young again............Id be heaps smarter than last time