electrical issue, please help?

[pasophist]

Hi folks:

My 907ie had no front turn signals because the previous owner didnt have them plugged in!

When I did plug them in, the left side worked fine- normal speed, but the right side blinks super-fast (front and rear).

One side normal speed, one side double fast. All the bulbs work.

Any ideas?

Thanks lots.
Sheldon

[injected]

Check the bulb wattages in the fast side. If not, it'll likely be the flasher unit.

If that fixes it, please see this thread! http://forums.ducatipaso.org/viewtopic.php?f=3&t=3257

[Tamburinifan]

My guess is bad ground/earth on the fast one.

[pasophist]

I switched the bulbs in the rear and the fast/slow swapped sides. So its the bulb. The rear bulbs are different. Does anyone know what bulb is supposed to be in there?

Thanks

Sheldon

[ducapaso]

This should be indicated in the lens. 21w/12v

[Finnpaso]

Just like Nicola say, 21W, but IF U change to halogen, or LED blinkers, then You have to change blinker relay also to "clever one", like Kellerman unit, or put resistor to series with bulbs. I just put another pairs of rear blinkers to my ST2 and only way to solve too fast blinking was to buy Kellerman unit!

[persempre907]

IF U change to halogen, or LED blinkers

Try with the right bulb before .
Ciao

[jetboy]

i just put LED blinkers on my 750 sport- but only the front - rears are still bulbs. I didn't have any trouble with fast blinking, but one small issue is the LED lights really need a full 12v or they wont turn on - with old ducati wiring the LED blinkers don't work at all with the bike off, hardly show at idle - but are bright and clear at 2000 rpm.

i was thinking of doing the rears to LED as well, but at stops im afraid they would hardly show--