ducatipaso.org

But the new front discs are lighter.

Let`s have a look at the thickness/wear of the rear disc:

And the front discs:

I think i had a little too much wear on my front disks...

Now the new swingarm is in place as well.
But there are two open issues with it:
The decals are still in production process, & i need all the bolts for the shock and so on new or to be zinc plated...

Looking for these parts:

037059030
037059080
037059070
037059120
729912FF1

I googled those numbers and found them all in a price list that`s on the website of Ducati Poland.
You could try to ask if they actually have them in stock. I guess you can even write them in german.
The contact is ducati@ducati.pl and/or zamowienia@monsterbike.eu . Not sure if the parts list is actually from Ducati or from that MONSTER BIKE shop in Warsaw so try both.

G.

Without the black frame, but finally some decals arrived!

Watch this!:

hey, they came out nice. Will you get others with the frame ?

G.

Don`t know yet. I asked him, but no reply until now. It may take another half a year....

Look what i have found in my archive! This is rear wheel power... I can`t wait to have this one back on the road.

Wooooowwww

Ciao

Just giving a short status w. some pictures.
I did a little progress the last days.

My exhaust cans are ready.
The old titanium tubes had dents and were not nice looking any more.
I replaced them w. carbon fibre tubes.

I tried some hours to get the damn thing open, after drilling the rivets nothing happend.
So i cut the tube. Thats what it looked like iside: And this is why i could not open it. The endcaps are welded on the center tube... (Marving)

And here the result: Then is was the headers` turn. They are good, but not good looking and too much heat emitting on the reat Wilbers damper and also heating up the space in the fairing.
Thats why i wrapped them in ceramic fiber cloth:

I received my zinc-plated swingarm bolts and some other parts last week. So i started with the (4th) reassemblyof the swingarm & rear monoshock. The new mudguard, etc... All parts, screws, bolts, nuts, plastic & rubber parts are new, new zinc-plated or painted. (except the connecting rods) Some parts i used were the the last available. You can see some dust on the parts, i can not avoid that... .