ducatipaso.org

Anyone here have a picture and dimensions of the swingarm pin for the rear-brake, caliper bracket? On the parts list, it is #037740070. This is the pin that is bolted to the inside of the swingarm to prevent the caliper bracket from rotating. I picked up a used 907 swingarm needing some work and it is missing this piece. The pin is no longer available from Ducati, so I was wondering what it looks like and it's dimensions so I can make one. Thanks!

Also, anyone have the left swingarm end cap that the axle adjustment bolt goes through (part #37310041A)? This is still available, but at $35 plus shipping, it is more than I spent on the complete swingarm.

Isn`t that the same pin on the 93-99 Monster swing?
Ought to be avaliable.

if it is the same as on a Monster swingarm, then it is the same as on an 888 also.



btw I would have all the parts you need but as a set and only shipment would cost more than what they ask for that part in US.

G.

is is noticeable I currently have time ?





the bolt is a grade 8.8.

G.

paso750 wrote:is it noticeable I currently have time ?

Thanks, Gerhard! You must have really been bored.

Is that from a 907 swingarm or a Monster or 888?

paso750 wrote:if it is the same as on a Monster swingarm, then it is the same as on an 888 also.

I'll check on the same part for the Monster/888 and see if that is still available. If not, I'll take those dimensions to my machinist friend and have him make one for me. I know where a 907 rear brake caliper bracket is, but I don't want to pay the high price he is asking. I may make him a lower offer and see if he'll take it. I'm hoping to have a complete 907 swingarm assembly for a future 17" wheel swap (if necessary).

Thanks, again!

the pictures and measurements are made from a spare 907ie swingarm I`m keeping for similar reasons as you do

RE Rear caliper bracket , 907 , Check US ebay - RPM CYCLE PARTS.....$30.00. BUY NOW. Hope its OK, .......Marty

gail wrote:RE Rear caliper bracket , 907 , Check US ebay - RPM CYCLE PARTS.....$30.00. BUY NOW. Hope its OK, .......Marty

Thanks.....I've actually been watching that one for a couple of weeks. I'm tempted on emailing them and see if I can get it a bit cheaper than that........

I gave the measurements for the pin to my machinist buddy, and he thinks he can probably make me one for less than Ducati probably wanted for one......it doesn't hurt that I was picking up $200 worth of parts for my Harley when I was talking to him about the pin.

Desmo_Demon wrote:I gave the measurements for the pin to my machinist buddy, and he thinks he can probably make me one for less than Ducati probably wanted for one....

You really have some good friends .

Ciao

persempre907 wrote:You really have some good friends .

Exactly!!! Plus, I can even get him to make me aluminum castings if I need something. He cast these a few weeks ago...